Preparing your datasheet

PRO-AR 12 & 16 channel

19" Rack-Mountable Receiver Multicoupler series for the VHF through low UHF bands 30 MHz - 960 MHz
Description
  • OBS: The Receiver Multicouplers PRO-AR4 & PRO-AR8 versions are discontinued.
    They are replaced by the present new Dual Amplifier Receiver Multicouplers PRO-DAR4 & 8 channel.
    PRO-DAR (www.amphenolprocom.com)
  • For use where a number of receivers have to share the same antenna.
  • Active wideband receiver multicoupler for the VHF and low UHF bands with 1 input and 12 or 16 outputs.
  • Allows a number of receivers to share the same antenna without interaction and loss of signal.
  • Wide frequency range: Covers 30 MHz – 960 MHz.
  • If only a smaller frequency range is desired, a preselector filter can be built in to prevent possible interference from strong transmitters outside the frequency band of interest. Amphenol Procom offer a wide range of both band selective and narrow-band low-loss filters suitable for preselector use.
    Please refer to the preselector overview and specify frequency range when ordering.
  • Ultra-high dynamic range amplifier built in to compensate for loss in multicoupler network.
  • Push-pull high-current amplifier design ensures outstanding multicoupler linearity and high reject of especially even-order distortion products.
  • Handles even very strong RF signals with negligible levels of IM and harmonic distortion.
  • Low amplifier noise figure ensures lowest possible S/N deterioration of the received and distributed RF signals.
  • High isolation between receiver outputs.
  • Operates on 230 V AC or 115 V AC mains supply 12 V or 24 V DC supply.
  • Galvanically isolated power supply with power backup function.
  • Automatic switching to DC supply if the mains supply fails.
  • ”POWER ON” lamp on front.
  • Mains supply connector: IEC type fitted with noise filter.
  • DC supply connector: Terminal block fitted with noise filter.
  • RF connectors: N-female on all ports (other types on request).
  • 19” rack module housing.
  • Only 2 HU (1 height unit = 44.45 mm).
  • Comes as standard with anodized alu. color front plate.
  • As option available with black powder lacquered front plate.


    Please Note:
    Power cable is not included, must be ordered separately, see Accessories.
Specification
Electrical
Power Supply 230 V AC models :
198 to 264 V AC 47 – 63 Hz/ Max. 0.16 A
115 V AC models :
99 to 132 V AC 47 – 63 Hz/ Max. 0.32 A
Model
PRO-AR12G-N
PRO-AR16G-NPRO-AR8G-N (To be discontinued)
PRO-AR12G-N (Will stay)
PRO-AR16G-N (Will stay)
Gain (Input To All Outputs)
2 dB2 dB
Frequency 30 – 960 MHz
Gain variance
< ±2.0 dB< ±2.0 dB
Max. Output Power @ 1 dB Compression (P1dB)
@ 30 MHz > 11 dBm
@ 174 MHz > 12 dBm
@ 400 MHz > 16 dBm
@ 960 MHz > 12 dBm@ 30 MHz > 11 dBm
@ 174 MHz > 12 dBm
@ 400 MHz > 16 dBm
@ 960 MHz > 12 dBm
Noise Figure, Amplifier
< 6.0 dB< 6.0 dB
Output 3. Order Intercept point (OIP3)
> 25 dBm> 25 dBm
Impedance 50 Ω
Output 2. Order Intercept point (OIP2)
> 50 dBm> 50 dBm
Max. Input Power (dBm) 18 dBm
Isolation between outputs 30 – 800 MHz : > 20 dB
800 – 960 MHz : > 18 dB
Input VSWR ≤ 2.5:1
With Preselector : ≤ 2.0:1, typ.<1.5:1
Input-Output Isolation
> 46 dB> 46 dB
Effective Noise Figure all outputs
< 8.0 dB< 8.0 dB
Output VSWR < 1.5:1
Current Consumption
PRO-AR12G-… : 1.4 to 1.7 A
PRO-AR16G-… : 1.8 to 2.1 APRO-AR8G-… : 1.0 to 1.3 A
PRO-AR12G-… : 1.4 to 1.7 A
PRO-AR16G-… : 1.8 to 2.1 A
DC Supply, 12 V DC types
10.8 to 14.4 V DC10.8 to 14.4 V DC
DC Supply, 24 V DC types
20 to 28 V DC20 to 28 V DC
DC Supply, 48 V DC types
40 to 60 V DCNot available
Environmental
Operating temperature range
-10 °C to +50 °C-10 °C to +50 °C
Storage temperature range -40 °C to +70 °C
Humidity < 90% non-condensing
Mechanical
Power Connector 3-terminal IEC60320-1 C14 (male)
Connection(s) N(f) (standard)
BNC(f), TNC(f) or SMA(f) on request
DC Connector 3-pole screw terminal block
Historic Brand Amphenol Procom
Dimensions PRO-AR12G-…, PRO-AR16G-… :
19″ x 2HU x 261 mm (482.6 x 88.1 x 261 mm) / (19 x 3.47 x 10.28 in.)
Altitude 0 to 2000 m
Weight PRO-AR12G-…, PRO-AR16G-… : Approx. 4.4 kg. / 9.70 lb.
Ordering Codes
Model Product No.
19″ Rack-Mountable Receiver Multicoupler series for the VHF through low UHF bands 30 MHz – 960 MHz PRO-AR 12 & 16 channel
Additional Information
Ordering designations

Contact for system-specific product no.

Use the guide below to make the name of the PRO-AR you would like to buy. Remember to buy the Power cable separately if needed.

Model
Front plate
No. of outputs
AC Power
DC Power
Antenna Connector
Rx Connector
Number of loads
Preselector filter
PRO-AR
Blank = blank **
Black lacquered = B
12 outputs = 12G
16 outputs = 16G
230VAC = 230V
115VAC = 115V
12VDC = 12V
24VDC = 24V
48VDC = 48V **
N-female = N
TNC-female = TNC
BNC-female = BNC
N-female = N
TNC-female = TNC
BNC-female = BNC
No load = blank *
One 1W load = 1L
Two 1W loads = 2L
Three 1W loads = 3L
No filter = blank
See tables with
preselectors below
Naming Example
PRO-AR
B
12G
-230V
/12V
-N
/N
-1L
BPF 118-137-C

Naming Example: PRO-ARB12G-230V/12V-N/N-1L BPF 118-137 C

* Terminating unused ports will secure the electrical performances of the RMC.
** 48V version not available for PRO-AR 12 & 16 channels.
** “Blank” means sign omitted.

Accessories
ModelProduct No.
Power Cable EU , with Ground 210002646
Power Cable UK , with Ground 210002647
Power Cable US , with Ground 210002648
Standard Low-Loss Preselector Filters for PRO-AR…G

Band selective standard blackbox filters (other filters on request)

TYPE DESIGNATIONFILTER TYPEPASS BAND FREQUENCY RANGE
BPF 66-88 Band pass 66 – 88 MHz
BPF 88-108 Band pass 88 – 108 MHz
BPF 112-136 Band pass 112 – 136 MHz
BPF 118-137 Band pass 118 – 137 MHz
BPF 118-174 Band pass 118 – 174 MHz
BPF 136-225 Band pass 136 – 225 MHz
BPF 146-174 Band pass 146 – 174 MHz
BPF 225-400 Band pass 225 – 400 MHz
BPF 300-500 Band pass 300 – 500 MHz
BPF 800-1000 Band pass 800 – 1000 MHz
LP 174-FME Low pass 0 – 174 MHz
HP 380-FME High pass 380 – 1000 MHz

Narrow band standard BP filters:

TYPE DESIGNATIONFILTER TYPECENTER FREQUENCY -1 dB BANDWIDTH
BPF 4/4-[BW] Band pass To be ordered within 66 – 88 MHz To be specified as 2, 4 or 6 MHz
BPF 3/4 Band pass To be ordered within 112 – 136 MHz 1.5 MHz
BPF 2/4-[BW] Band pass To be ordered within 144 – 175 MHz To be specified as 2, 4 or 6 MHz
BPF 70/4-HX Band pass To be ordered within 380 – 470 MHz To be ordered within 3 – 15 MHz
BPF 900/4 Band pass To be ordered within 820 – 960 MHz Typ. 7 MHz
EU and UK Declaration of Conformity

Hereby Amphenol Procom declare that the product type PRO-AR…G is in compliance with EU Directive 2014/53/EU and
the UK Radio Equipment Regulations 2017 (S.I. 2017 No. 1206).
The full text of the Declaration of Conformity is available at:

https://s3.us-west-2.amazonaws.com/catsy.1080/Declaration-of-Conformity-PRO-ARxG.pdf

Model Housing – PRO-AR12G-N or PRO-AR16G-N back side

PRO AR8G back front

Model Housing – back side

PRO-AR8G-N

PRO AR8G back front
PROCOM A/S reserves the right to amend specifications without prior notice
PROCOM A/S • Smedetoften 12 DK 3600 Frederikssund • Denmark
Generated : 2026-07-17 Version 1